Wednesday 24 July 2013

Spellbinders fancy lattice through the machine

Here is one of the dies that cause lots of problems . Setting between 1&2 , we ran this through once and back once . We again used the spray m boss before we cut . Gordon











6 comments:

  1. I have a spellbinder shapeability die (poinsetta) and after playing around with the pressure slider I found I needed pressure 4 for the die cut part, then when I put back in for the embossing part I used the setting 9. The vein part didnt emboss very well at a higher number so decreased down by one and found that 9 for me was just right. I also found that when using the TH alteration dies, I needed to have the pressure set at 17 and it cut with one pass. I expect others may well find they can go lower with their pressure setting but 17 was fine for me.

    ReplyDelete
    Replies
    1. The pressure switch is there to be used and not to be afraid of . I am glad to hear you are doing well and finding how the machine works best for you.
      Gordon

      Delete
  2. What cardstock were you using? Thats also important to know.

    ReplyDelete
    Replies
    1. We are using hunkydory 250 gram cardstock which i recommend to anyone

      Delete
  3. My Machine is missing the gauge around the slider, making setting really tricky, can anyone help?

    ReplyDelete
    Replies
    1. Hi
      Please give me a ring on the number we provide on the instructions and we will sort this out for you . Remember though , the instructions are merely a guide , the pressure is in your hands as the instructions say . Dont be afraid of the pressure switch , find the pressure that works best for you , thats all you have to do and then you will be off and running

      Delete